I replaced my trailer boards at the launch ramp parkin lot
[QUOTE=waterdog101;569010]I replaced mine last year, and I used treated 2 by 4’s with the carpet I bought at Lowe’s, the carpet is made from recycled plastic, and I used the spray can glue, and picked up the new bolts that hold the boards to the trailer, I lunched my boat and tied it to the dock, pulled trailer up to parking lot, and replaced the boards, then loaded boat and finished job, I don’t remember the exact dollar amount, but the time was about an hour total, half hour to glue the carpet to the boards at home and dry over night, and about half hour or less to blot them to trailer at boat ramp. It’s so easy a Republican could do it.
or a Democrat[/QUOTE]
I replaced the side bunks on my boat trailer. Howsclaw Trailer made in Evansville, IN back in the 1970's.
I did the same thing but I used a 12 volt to 115 V converter to power a air compressor and then used a pneumatic staple gun to put the marine carpet on the new boards. A portable drill to drill the new holes in the wood and then installed the new boards on the trailer while the boat was offloaded and parked along the shoreline near the ramp. Took me a while to setup and do the job. I used regular two by four wood.
Note: Treated wood is treated with arsenic compounds to keep insects at bay. I suggest using a water proofing liquid and brushing it onto the wood at home to water proof the wood. Or if you buy the wood make sure that when you ask for treated wood that you tell the salesman you man water proofing treatment on the wood not insect treatment. Maybe you can buy the insect treated type wood and then coat it with some Thompson's water proofing stuff. You want to keep the wood from rotting over time so that's why I water proofed it.
I got the marine carpet at Home Depot. Just used indoor/outdoor carpet.
For the bottom boards that the boat sits on I used some 12ft long 2x4's on Edge and put carpet on the top edge that the boat sits on. But the carpet was adding too much friction between the bottom of the boat and the carpet. So I added some plastic to the top of the board and now the boat slides off real easy. You can buy the plastic pads at Bass Pro Shop and screw them onto the top of the board ever 6 to 12".
[url]https://www.basspro.com/shop/en/e-z-slide-trailer-pads[/url]
Changed my pontoon bunks this spring.
They were 9 years old. I went to Lowe's and bought 2x6's because the pontoon sets on the big side in a V shape. I wanted more bunk to hit when loading the tub. Bought my carpet on Ebay for half what I saw everywhere else. It is designed to get wet. Water should drip dry soon after unloading or loading. I used exterior carpet glue and also stapled the carpet to insure it stuck good when glue dried.
I don't think Bass Pro used weather treated wood. I bought my boat/trailer at age 8 and the bunks were so rotten I was surprised. I never saw the trailer without the boat on it until I rented a slip. I was lucky the boat didn't fall off in the middle of the road somewhere. The strap wasn't very good either.