Hydraulic Jack Plate???

[rudeZ20]

Hello Fellow fishermen/women,

I curretnly have a manual 10" jack plate on my boat, however I am looking into getting a hydraulic one. Seems as though tuning it in to keep the prop in clean water would be a helluva a lot easier. Anyhow does anyone have any sugesstions on a manufacturer and a model? Please give your good and bad points also.

Thanks much,
Marty
RudeZ20

[VMAXX]

Marty I went with a Bobs on my new ride and my old had a cmc... my .02 is the Bobs is quieter,smoother and quicker up, I'll stick with Bobs from now on.

[Bill Day]

I think the Bob's is better. I have sold and used both brands but the Bob's seems to last better. I wouldn't spend the money if you are buying it as a tuning aid as all the Z boats we have sold all seem to run better at about the same height, i.e. 2 inches above the bottom setting.
Bill

[EtecRanger205]

I'm with bill, buy a bob's. I have the one that the pump is in the boat. I like it better than the pump on the outside. I had a slight problem with the gauge, and they took care of it right away and even out of warranty. You won't be sorry.

[Toadman]

Get a Bob's.