what is the best head for fnf the minner head or asprin head wonting to make and ty some jigs
Printable View
what is the best head for fnf the minner head or asprin head wonting to make and ty some jigs
It's all personal preference, IMO. Minnowhead is good and available from Do-It molds. Asprin mold may be little tougher to find, not sure of the weights it comes in. Some use bullet-shaped heads that work. Round ballhead will work just fine, also from Do-It. Just be sure to use the hooks that the mold recommends. You can go up one hook size on the minnow mold, i.e. a #1 in the 1/16 as opposed to the standard #2, but the amount of worthless pours will probably increase also. That's what I've experienced so far.
Good Luck and Happy Holidays,
UpaCrick
With a small file or pocket knife you can increase the size of the hook slot if you will always be pouring with larger hooks. I do this on my molds for striper jigs. Just go slow and check often.
Andrew