Finally got out on the water with the Conquests this week.... I got 14 of them in the following models: 905C, 904C, 903C, 842C and 842S. On the casting rods I have Aldebaran 50's on them all and the spinning models I have Exsence 3000's on them. Got to fish with all models except the 905C, which arrived at my house while I was at the lake... I will say with the 905C just feeling it in my hand it balances WAY better than my NRX 895C did, the 905C is not tip heavy at all...
I owned all NRX's prior to upgrading and the Conquests have a more "solid" feel, hard to explain but the NRX's felt "hollow"/brittle in comparison. I noticed the casting was more "fluid" with the Conquests and the guides were quiet, sometimes on my NRX's I could hear the line go through the recoil guides during a cast or when fighting a fish. I do like the full cork grip on the Conquests and its a very smooth cork feel in hand, no pits/rough spots like a couple of my NRX's had.
I can't "with the naked eye" tell a weight difference between the Conquest and NRX, but they do feel stronger/more "solid" than the NRX. I caught several 3lb-4lb class fish on them including a 6lb and they all handled the fight of the fish great, I even caught a 5lb on the 842S paired with an Exsence 3000 with 8lb line. And I don't know if it's the reel or the rod or a combination of both, but the 842S with the Exsence 3000 casted like a dream! Farther and with less effort than with my NRX 852S w/Sustain 2500.
I was a little worried at first with the "fast" action of the Conquests vs the "extra fast" of the NRX's but it wasn't an issue. I fished the same baits on the Conquests that I did with the NRX's and the rods handled the baits fine. I met the lure weight limits on each model I fished with, zero issues.
Sensitivity is slightly better, not as noticeable as say from a E6X to a GLX. Now, is "slightly better" worth the roughly 20% higher cost of the Conquest vs NRX? That's up to you... I'm a gear junkie so it was worth it to me!
If you can swing the coin, I highly recommend them!



Reply With Quote

