Customizing a 16ft. Jon Boat?

[DJD]

Did you make that floor on your own? If not, can you tell me who did and how much it cost? Thanks for any info.

[bluegilln]

DJD

I did it myself. I got a sheet of aluminum from Evansville Sheetmetal and cut it to fit. Once I had it cut to fit I put the rivets in. The rhino liner dealer here in BG KY taped/caulked it nice, it is seamless. Give me your email and I will send pics. Sorry to take so long getting back, I travel some for work and don't get to check in as much as I would like :).

[DJD]

I am in and out alot as well. I appreciate your response and look forward to some pics. My email is [email protected]
Thanks, Don

[bluegilln]

Hopes this gives you some ideas.

[birdstrike]

Hi Bluegilln,

I was looking to do the same thing. Can you tell me a little more about how you did this? What gauge metal did you use? About how much does it sell for? I'd love to see a picture or two of your rig! Thanks, Steve Louisville, KY


Tried you email and it didn't work. You can reach me at [email protected]

[bluegilln]

Sorry Birdstrike,

I took some photos of the back deck I put in. Let me know if you get them. I used angle aluminum as "joists" then laid the .100 sheet down. You can look on Xpress's sight for a before picture. 16' tunnel hull flat bottom with the corner pods. My deck and all of the angle cost a little over $200 the best I can remember. If you need more pictures or additional detail let me know.

Chris