Search Fishin.com

Results 1 to 6 of 6

Thread: Info needed

  1. #1
    Join Date
    Dec 1969
    Location
    .
    Posts
    37
    Post Thanks / Like

    Info needed

    I am a far cry from being a engine repairman. I need some advice from someone who knows a lot more than I do.
    I had a problem on the water yesterday after many years of no problems. After getting home I found the fuel bulb on my 150 Johnson is not staying tight and my motor will start to run rough after a few minutes. when I squeeze the bulb a few times it will straighten right out and purr. Here is the thing. I cannot find a leak in the gas line anywhere. I know it s getting air from somewhere. I am going to replace the whole fuel line anyway because it is due, my question is could this be something else that I am overlooking?
    Thanks in advance for your input.

  2. #2
    Join Date
    May 2007
    Posts
    44
    Post Thanks / Like

    Re: Info needed

    the bulb does not stay hard after the engine runs a little. if the engine continues to run while you pump the bulb, your problem is a bad fuel pump.

  3. #3
    Join Date
    Jan 2009
    Location
    Shepherdsville,Ky
    Posts
    129
    Post Thanks / Like

    Re: Info needed

    I'm just guess but if the fuel line is quite few year's old it could be getting dry rotten and bleeding seeping air. Just a thought.
    Dog

  4. #4
    Join Date
    Mar 2009
    Location
    Morristown IN
    Posts
    45
    Post Thanks / Like

    Re: Info needed

    If you have a main tank and a reserve tank your valve to switch tanks could be leaking by too. A buddy of mine had that problem. Gilly is probably right about the fuel pump though. I have had the same symptoms and the fuel pump solved my problem.

  5. #5
    Join Date
    Dec 1969
    Location
    Sullivan, Indiana, USA.
    Posts
    25
    Post Thanks / Like

    Re: Info needed

    Quote Originally Posted by dmase View Post
    I am a far cry from being a engine repairman. I need some advice from someone who knows a lot more than I do.
    I had a problem on the water yesterday after many years of no problems. After getting home I found the fuel bulb on my 150 Johnson is not staying tight and my motor will start to run rough after a few minutes. when I squeeze the bulb a few times it will straighten right out and purr. Here is the thing. I cannot find a leak in the gas line anywhere. I know it s getting air from somewhere. I am going to replace the whole fuel line anyway because it is due, my question is could this be something else that I am overlooking?
    Thanks in advance for your input.
    When is the last time you replaced the primer bulb? The bulb it self could be bad. They do go bad over time. I have a similar problem. My primer bulb goes soft when sitting to long in the sun. Only when it is warm out side. In the 80's. But once I change my primer bulb, I am good for a year or so. If you replace your primer bulb and you still have problems, then yes, it could be your fuel pump. Or some restriction from your tank. A new primer bulb is a cheap fix before taking it in to a shop.

  6. #6
    Join Date
    Feb 2009
    Location
    Bowling Green
    Posts
    18
    Post Thanks / Like

    Re: Info needed

    Fuel pump

Similar Threads

  1. info needed
    By dkprofishn in forum Kentucky Discussion Board
    Replies: 0
    Last Post: 04-11-2010, 11:31 AM
  2. info needed
    By rickhise in forum Kentucky Discussion Board
    Replies: 2
    Last Post: 03-02-2008, 11:17 AM
  3. KY Lake info needed
    By TritonKTB in forum Kentucky Discussion Board
    Replies: 5
    Last Post: 03-15-2007, 05:37 AM
  4. Taylorsville Info Needed
    By bassinyouth in forum Kentucky Discussion Board
    Replies: 1
    Last Post: 10-07-2006, 02:02 AM
  5. Watts bar info needed
    By Tnstratos283 in forum Kentucky Discussion Board
    Replies: 10
    Last Post: 08-14-2006, 05:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •