Depth finder problem

[Bass Addict 170]

I'm no expert, but if somehow a bubble has formed between it and the hull, you could try putting enough water in the hull to cover the mounting surface where the puck is. If a bubble is causing the problem, this would fill it with water and make it work again.


Clint

Actually, Clint's pretty close. I would say one of two things, either like he said about having an air bubble form (however less likely if it has worked a few days/week before and had time to set), or it didn't set properly and possibly has a crack or seperation in the epoxy. Sometimes using 5-min vs. 30-min epoxy can create problems like this, or if you didn't sand/prime the area of fiberglass you put the transducer. But just to make sure, you did epoxy a "shoot-thru" transducer and not a "Thru Hull" one right?