I have an old Carb 115 Evanrude, had went about 2 miles down the lake today running 4000 rpm and the thing acted like was runing out of gas then stop.Well I could start up but it would stop, and then it wouldn't start at all. So I set there and fished for about 10 min, and it started again. So I baby the the thing around running 3000rpm and it did fine. When I was going back to the dock, and gettin close, I open her up to 5000rpm and let it back to 3000 then again to 5000 and it done it again. Set there 10 min. started went to the dock and loaded up, after laughing at all thase people unloading. I'll sure they would get a good laugh out of my typing, any ideals guys?