Evinrude Mechanical Question

[HoosierDon]

This might be a long shot but, how much more gear are you hauling around compared to 5 years ago?? It's funny how all that stuff adds weight and weight slows you down.....by the way, Lynns Westside Marine in Evansville has an exellent E-Tec mechanic.....

[rudeZ20]

BRL and Don,

Thanks for the insights. As for the mentioned possiblities. NOt hauling around any more gear than when I first purchased boat, actually probably less. I will check the gas line and see if that could be an issue. Just had new plugs, fuel filter and 1 injector replaced about 4 months ago. No changes made to prop, jack plate. thanks again.

[dac244]

Have you checked your pad?

[rudeZ20]

My "MAXI" is fine(lol) THANKS FOR ASKING

[dac244]

I just know when some wax a boat they will wax the pad and that is not a good thing.

[CTFSHWHISKER]

is the top speed the same?may be a throttle position sensor,throttle adjustment,etc..not opening to wot.does not take much to slow down hole shot but would still run close on top end.

[olgreenboat]

could just be a plastic clip on the trotle linkage they do brake alot..

[otisray]

Try posting your question on this site, alot of good help for e-tecs

http://www.etecownersgroup.com/?forum=115573&trail=25