These are both great ideas, but if you use either king board or just a plastic cutting board instead of plywood, it will last forever. We made a rod locker organizer for a Nitro with this method and it looked better that the factory organizer. Use carboard and make a template of the inside of you locker. This will take a little while, but if you take your time, it will be worth it. Transfer the template to a large plastic cutting board and cut it out. Hint, use a jigsaw on a very slow speed to cut the plastic board. We then drilled holes for the golf club tubes. The large golf club tubes are best and can be bought at Dicks, Walmart or any golf supply store. With the tubes in place, the plastic board will wedge tightly into place and not move, even in the roughest water. For the handles we used more of the plastic and cut it into a pice that was about 3 inches deep and as long as the width of the locker. We then and cut V's into it where we wanted the handles to sit. We had two rows of these, 1 on top of the other and mounted to a couple of 2x2 pieces of treated lumber which was screwed into the back wall. We carpeted the lumber. This locker now holds 11 rods and they never get tangled. It was a fun project and we had great results!