Bent Skeg

[silvercreek]

Any suggestions to straighten a slightly bent skeg on a 40 hp mercury? It has a small curve to it? Thanks

[Embrey]

if its not affecting operation dont mess with it. mine was BAD,and i got it back with a crescent wrench and a little selective torch use. too much and youll snap it and be in worse shape

[silvercreek]

if its not affecting operation dont mess with it. mine was BAD,and i got it back with a crescent wrench and a little selective torch use. too much and youll snap it and be in worse shape

Thanks, it don't affect the operation, I will leave it alone.