Johnson 35 HP problem

[Bardcard]

Pulled the prop back off, but don't understand the "offcenter" ? Do see the rubber "sleeve" in the prop, but how can you tell if it is slipping?

Thanks,

[Embrey]

put the motor in gear (NOT RUNNING) and see if you can make it slip by hand

[Bardcard]

Have come to the conclussion that it is the prop slipping. Looks like the sleeve has moved 1/4" within the prop.
Put an old beat up prop on, it did not slip. Put newer prop on, it slips.
What now? New prop? Rebuild prop?
Any suggestions?

Thanks,

[billm_usa1]

you can probably pick a prop from E-bay for $25 or $30

[LJP]

Have come to the conclussion that it is the prop slipping. Looks like the sleeve has moved 1/4" within the prop.
Put an old beat up prop on, it did not slip. Put newer prop on, it slips.
What now? New prop? Rebuild prop?
Any suggestions?

Thanks,

You can send it off or find somebody close and have a new hub put in less then $75.

[R19]

What you are describing sounds like a spun hub. A friend of mine spun a hub on his motor and I was thinking it cost him $35 to press out the old hub and install a new one.