Just started mixing my gas and oil.

[peter]

Hey Guys,
I have just started mixing my oil and gas recently. Yeah, finally disabled the oil VRO system. I have a question... I'm mixing 1 ounce of ethanol treatment to 10 gallons of gasoline. I'm using 50:1 on my oil to gas mixture. This may not be a good idea, but what would be the correct ratio of ethanol treatment to a gallon of oil? If its not wise to mix the two, please give your thoughts. Thanks for all comments.

Just fill up the tank. Add the proper amount of oil. Add the proper amount of gas treatment as indicated on the label.

Get a clear tallish plastic container (preferably with a lid). Measure the proper amount of ounces of oil per gallon with a kitchen type measuring thing where you can measure ounces. Measure and pour the proper amount of ounces of water for one gallon of gas in the container and mark it 1 gallon with a sharpie. Do the same thing and mark it 2 gallons and so on. This is much easier than doing the calculations over and over.

Bass pro makes a ready made measuring container that does this same thing.
Wallgreens sells a plastic container for drinking with a red top that is about 3.5 inches x 3.5 inches by four or eight inches tall.

I put gas treatment in every time I fill up. You never know when you might not be able to use the boat for a few months and this way you don't have to remember what you did.