Here is a photo of one of the PVC Crappie trees I made a few years back. I found an old roll of film in my camera and took it to CVS to get it developed and put onto a CD. I just viewed these pictures last night and found these photo's of the PVC tree that I made. These pictures were taken over a period of several years and date back a few years into the past.
This is the almost completed tree. I didn't add all the cross branches yet but you get the idea what it will look like if you imagine that all the holes are filled with smaller PVC branches.
Here is a closer photo of the base which is filled up with conrete and then glued to the top of the tree.
And this is the top portion of the Tree. Note the expanded area where the bottom fits into the top part of the tree.
Sorry about the quality of these pictures. They looked a lot larger in my photobucket album
I would not have posted them if I had known they would be that small in here. I'll have to work on my picture posting skills. It's hard to tell how large or small they will appear in this web site just by looking at them on the Photobucket album. They look so much larger in my photobucket album than they do in here. I even went back into my photobucket album and tried to resize them larger but that didn't seem to work either. I give up.
Last edited by Moveon; 10-26-2011 at 03:47 PM.
OK lets try these pictures instead.
First Photo is of the almost completed tree:
This is the coupling where the base fits in:
This is the base filled with concrete:
These pictures are much larger and easier to see. I learned something about using photobucket today.